@@ -1,1 +1,1 @@ - +<br>The most common threaded pipe and large pvc pipe fittings are those that have two holes drilled into them for the threads to be inserted into. This is not the case with the Apollo 2 inch ball valve. If you have any questions pertaining to where and ways to utilize [https://Www.Inoxcamlockfittings.com/hose-coupling-chicago/ Hose-Coupling Chicago], you could contact us at the web site. You have the option of choosing any threaded pipe or large pvc pipe fittings from the many different manufacturers available today, but it is very likely that the Apollo 2 inch will not be one of them.<br><br><br>This is simply because it was never intended to have a threaded connection on the inside of it, which defeats the very purpose of having a ball valve in the first place. The reason that the ball valve was invented was for the purpose of keeping excess moisture out of the condensing steam boiler, and it did a great job of that, but as time went by, people realized that the valve was becoming inefficient because the water in the boiler was not being eliminated as fast as it should be. When you have a large pvc pipe and a large threaded pipe fitting like the Apollo 2 inch, it is not an issue because the inner seal is not going to be obstructed at all. This is because when you have a threaded pipe fitting like this, you can make almost any diameter hole that you need.<br><br><br>The first valve that was ever made was the original Apollos 2 inch ball valve, and it worked pretty well for quite some time, but eventually gave up the ghost. People were searching for better ways to eliminate condensation from the boiler and the original idea was to build a condensing boiler with copper piping that would suck all of the water out. This would work, but the copper tubing would corrode and would be a health hazard to anyone that worked inside of it. It might even cause the worker to be killed. There were many other solutions to this problem, but none were as good as the original.<br><br><br>With modern technology comes even newer inventions, and the next big thing was the threaded pipe valve. The threaded pipe was used because it was very simple to make. You just took a large pvc pipe and cut it to the right size, drill some holes in it, and attach the threaded portion to the valve itself. The problem with this is that the threaded pipe was also a health hazard, because it had tiny little glass pieces in it that could easily cut a person's finger if they were to get their hand in close enough to it. This caused a lot of problems, so the manufacturers finally came up with the threaded pipe valve.<br><br><br>They basically put two caps over the threaded portion and welded them on to the bottom of the valve. This solved the problems of the small glass pieces, but there was still the problem of having to constantly change the caps and clean the valve parts off. The new valve parts looked much better than the old ones, but they still had the problem of having to take the valve apart every few months, so the company eventually went with a different approach. Instead of putting the cap back on after it was cleaned, they just put the valve in and started using an oil based lubricant instead.<br><br><br>That lubricant was supposed to keep the parts smooth to the touch, and it did help a little bit. Over time, the friction between the valve parts began to wear them down, and they started to leak. So instead of buying another set of Apollo 2 inch ball valve parts, they eventually replaced the whole valve with an oil-free, synthetic version that is supposed to keep the valve parts working for longer. This solution seems to have fixed the problem, as the company has recently been able to produce and distribute its own synthetic oil free valve, which seems to be working much better.<br>